HXE-WF750 Coiler for Intermediate copper wire drawing machine
I. Main technical parameter
1. Applicable diameter 0.4mm-1.6mm
2. Motor AC 15kw, Speed 1200m/min, adjustable
3. Coiler basket size 750mm
4. Small electric cabinet, 1 set, to connect with the drawing
machine control system
5. Tension device required, if your drawing machine has Tension
device, then no need.
6. Traverse motor AC 1.5kw
7. Speed reduction motor 90w
8. Speed control by Inverter 15kw
9. Air compressor shall be needed during working
10. Basket changing system is equipped
11. Basket block device is equipped
11. All ladders and blockers (Yellow parts) (Screws to fix) will be
removed before shipping
12. The down half part of the Coiler will be removed before
shipping
13. Needs connection wires from the Coiler to the drawing machine
control system
II. Application
WF750 Coiler for intermediate copper wire drawing machine is used
to take up wire from 0.4mm-1.6mm.
III. Operation & Maintenance
Preparation before running
Check all the lubrication parts of the transmission parts.
Check Wire-break Auto stop device, Safety doors.
Check coolant water, Lubrication oil, Steam, Compressed air.
After checking, jogging machine as lower than 5m/s, check all parts
again.
Operation
Connect power.
Prepare the drawing dies.
Prepare the wire pointing and threading.
According to the die list, place the wires on the capstan, wire
goes through each layer 2-3 times.
Put wire through the fix speed capstan then through the annealer
machine
Annealer machine wire path, please check the Wire path drawing on
the machine.
Then put wire through the Wire passing wheels, Tension device,
Spooler machine.
After the wire path, close Safety door, adjust Drawing lubrication
oil, Coolant water, Steam, Compressed air.
Maintenance
Lubricate all the parts, make sure all the wheels and capstans run
flexible.
After working 1000hours, clean all the bearing and change new
lubrication oil.
Annealing contact rings are consuming parts, after using for
certain time, when annealing, will have sparks, which means you
need change new rings.
There are carbon brushes on the back side of the annealer machine,
need change accordingly.
IV. Advantage and after-sale service
A: Advantage
(1). HENGXIE has some world famous parts suppliers, has special
lubrication system for the gears and bearing.
(2). Body and other key components and parts are produced by our
own factory , quality is reliable.
(3). Our company’s developing process in more than 10 years.
B: After-sale service
Our company for all machine product, since the shipment date, our
company free after sale maintenance service guarantee period is:
(1) 1 year for mechanical part.
(2) 6 month for electrical part.
